INCH-POUND
MIL-DTL-40082C
16 May 2003
SUPERSEDING
MIL-H-40082B
17 September 1992
DETAIL SPECIFICATION
HUBS AND DIES FOR HERALDIC ITEMS
This specification is approved for use by all Departments and Agencies
of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers steel hubs and dies used primarily for extracting
working dies used in the manufacture of heraldic insignia.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they
must meet all specified requirements of documents cited in sections 3 and 4 of this
specification, whether or not they are listed.
2.2 Non-Government publications. The following documents form a part of this document to
the extent specified herein. Unless otherwise specified, the issues of documents are those cited
in the solicitation or contract.
ASTM INTERNATIONAL
ASTM-A681 - Tool Steels Alloy, Standard Specification For
ASTM-E18 - Standard Test Methods for Rockwell Hardness and Rockwell Superficial
Hardness of Metallic Materials
(These standards can be obtained from ASTM International, 100 Barr Harbor Drive, West
Conshohocken, PA 19428-2959 or www.astm.org.)
Comments, suggestions, or questions on this document should be addressed to Department of
the Army, The Institute of Heraldry, Technical and Production Division, 9325 Gunston Road,
Building 1466, Room S112, Fort Belvoir, VA 22060-5579 or haassw@tioh.belvoir.army.mil.
Since contact information can change, you may want to verify the currency of this address
information using the ASSIST Online database at www.dodssp.daps.mil.
AMSC N/A
FSC 8455
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business