NOT MEASUREMENT SENSITIVE
MIL-DTL-15665J
6 April 1998
SUPERSEDING
MIL-I-15665H
29 April 1994
MIL-I-3575F
5 January 1989
DETAIL SPECIFICATION
INSIGNIA, BRANCH OF SERVICE, HAT, GARRISON CAP AND SERVICE CAP,
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1.
SCOPE
1.1 Scope. This specification covers insignia used for branch of
service, hat, garrison cap and service cap used by personnel of the Armed
Forces (see 6.1).
1.2 Classification. The insignia covered by this specification will
be as specified on the applicable military specification sheet (See 2.1
and 6.2).
2.
APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in
sections 3 and 4 of this specification. This section does not include
documents cited in other sections of this specification or recommended for
additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they
must meet all specified requirements documents cited in sections 3 and 4 of
this specification, whether or not they are listed.
2.2
Government documents.
2.2.1
Specifications, standards, and handbooks.
The following
Beneficial comments (recommendations, additions, deletions) and any pertinent
data which may be of use in preparing this document should be addressed to:
Director, The Institute of Heraldry, US Army, 9325 Gunston Road, Room S112,
Fort Belvoir, VA 22060-5579, by using the Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this document.
AMSC N/A
FSC 8455
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business