MIL-DTL-3628/64H
-5: 27/32 inch (REF)
-6: 57/64 inch (REF)
WIDTH (overall):
-1 to -3: 1-5/8 inches (REF)
-4 to -6: 1-7/32 inches (REF)
THICKNESS (at thickest point):
-1 to -3: 0.135 inch ± 0.010 inch
-4 to -6: 0.110 inch ± 0.010 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Piercing shall be as indicated. However, piercing for mid size badges shall be at the
option of the manufacturer.
3. The attaching device shall be prong and clutch type. Two prongs shall be located
on the reverse at the intersection of the horizontal center line of the badge and the
center of each side of the wreath.
4. Army badges -1, -2, -3 may be manufactured with a dull, flat black enamel finish
and shall match FED-STD-595, chip number 37038.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Air Force - 11
Review activities:
(Project No. 8455-2007/010)
Air Force - 99
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the
currency of the information above using the ASSIST Online database at
2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business