MIL-DTL-3628/50F
ATTACHING DEVICE:
1: Attaching device shall be prongs and clutches type.
2: The prongs shall be located on the horizontal center line of the badge equidistant from
each end and 1-1/8 inches + 1/64 inch apart.
3: The badge shall be dapped 1/16 inch in the horizontal direction.
NOTE:
The term (REF) refers to the measurements taken from the Government furnished hub or die.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodians:
Preparing activity:
Army - IH
Army - IH
Air Force - 11
Review activity:
(Project No. 8455-2014-099)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business
