MIL-DTL-3628/31H
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The attaching device shall be prong and clutch type. Prongs shall be located on the
horizontal center line, equidistant from each end. Prongs for -1 shall be 2-1/8 inches ±
1/64 inch apart. Prongs for -2 shall be 1 inch ± 1/64 inch apart.
3. A mock forcer may be used to bring up the design of the parachute.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy NU
Review activities:
(Project No. 8455-2010-078)
Navy - MC
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the currency
of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business