MIL-DTL-3628/23H
WIDTH (Overall):
-1, -4: 3 inches (REF)
-2: 1-3/4 inches (REF)
-3: 1-1/4 inches (REF)
THICKNESS: (At rim of cross): 0.060 inch + 0.005 inch
ATTACHING DEVICE:
1. The attaching device shall be prong and clutch type.
2. The prongs shall be located on the horizontal center line and equidistant from each
end. The prongs shall be 2 inches + 1/64 inch apart for -1 through -4. For -2 and -3, the
prongs shall be 1 inch + 1/64 inch apart.
EPOXY: Epoxy resin shall be light blue shall match TIOH Color Chip No. 30. Epoxy resin
shall be smooth and flush with the bottom edge of the rifle. The epoxy need not be stoned.
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished hub or
die.
2. A forcer may be used to bring up the musket only.
3. -1, -2 and -3 may be nickel or rhodium plated with a mirror-like polished finish for
commercial sale and shall match TIOH Metal Finish Chip Number 16. The silver plating
requirement shall not apply for nickel or rhodium plated insignia.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activity:
(Project No. 8455-2014-097)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business