MIL-DTL-3628/21H
ATTACHING DEVICE AND LUGS:
1. Lugs shall be located equidistant from each end and 0.675 inch + 0.015 inch - 0 inch on
centers.
2. The attaching device shall be prong and clutch type.
3. The prongs shall be located on the horizontal center line equidistant from the sides and 3/4
inch + 1/32 inch apart.
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished hub or
die.
2. A forcer may be used to bring up the wheel.
3. The basic badge covered by this slash sheet shall be used in conjunction with the
badge clasps covered by specification slash sheet MIL-DTL-3628/22.
4. Badge may be nickel or rhodium plated with a Nickel Plated, Mirror-Like Polished and
shall match TIOH Metal Finish Chip Number 16 for commercial sale only. For nickel or
rhodium plated items, the silver plating requirements shall not apply.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activity:
(Project No. 8455-2012-158)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business