MIL-DTL-3628/105D
WIDTH (overall):
-1 to -3: 1-5/8 inches (REF)
-4 to -6: 1-7/32 inches (REF)
THICKNESS (at thickest point):
-1 to -3: 0.105 ± 0.005 inch
-4 to -6: 0.090 ± 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Piercing shall be as indicated for all the regular and mid size badges except that the
mid size master badge (-6) shall not be pierced in the area of the wreath and star.
3. Attaching device shall be prong and clutch type. Two prongs shall be located at
each intersection of the horizontal center line of the badge and the center of each side of
the wreath.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was
done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Air Force - 11
Review activities:
(Project No. 8455-2010-112)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the currency
of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business