MIL-DTL-1563/3B
DIMENSIONS:
HEIGHT: 1-3/32 inch (REF)
WIDTH: 7/8 inch (REF)
THICKNESS (On helmet): 0.080 inch ± 0.005 inch
MARKING FOR IDENTIFICATION: Back of Insignia
FINISH:
-1: BASE: Black Epoxy Resin (Stoning Epoxy), Gold Plated, Polished Finish.
DEVICE: Gold Plated, Polished Finish.
-2: BASE: Black Baked Enamel.
DEVICE: Black Baked Enamel.
-3: BASE: Gray Epoxy Resin (Stoning Epoxy), Gold Plated, Polished Finish.
DEVICE: Gold Plated, Polished Finish.
-4: BASE: Olive Drab Baked Enamel.
DEVICE: Brown Baked Enamel.
-5: BASE: Gold Epoxy Resin (Stoning Epoxy), Gold Plated, Polished Finish.
DEVICE: Gold Plated, Polished Finish.
-6: BASE: Brown Baked Enamel.
DEVICE: Brown Baked Enamel.
EPOXY: Epoxy resin (Stoning epoxy) area for -1, -3 and-5 shall be as indicated, and shall
match The Institute of Heraldry (TIOH) Hard Enamel Color Chip Numbers listed below.
COLOR
CHIP NUMBER
BLACK
26
GOLD
31
GRAY
27
Baked Enamel for -2, -4, and -6 shall match the color chip number of FED-STD-595 as
follows.
COLOR
CHIP NUMBER
BLACK
37038
BROWN
20095
GREEN (Olive)
34096
ATTACHING DEVICE:
1. Attaching device shall be prong and clutch type.
2. Two prongs shall be located on the vertical centerline, equidistant from each end and
3/4 inch + 1/64 inch (1.91 cm + 0.04 cm) apart. When epoxy resin is used, rivets shall be
used to attach the device to the shield.
Page 2 of 3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business