MIL-DTL-11484/50G
EAGLE:
HEIGHT (overall): 5/16 inch (REF)
WIDTH (overall): 5/16 inch (REF)
TOTAL THICKNESS (at center): 0.100 inch ± 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Enameled/epoxied areas shall be as indicated. The colors shall conform to the TIOH
hard enamel color chip numbers listed below.
COLOR
CHIP. NO.
Red
1
Green
11
Blue
20
Black
26
White
28
When epoxy is used, the material requirement shall be not less than 85/15 rich-low brass.
When enamel is used, the material requirement shall be 95/5 gilding metal.
3. Pierced areas shall be as indicated.
4. The device may be either soldered or riveted to the base.
5. Attaching device shall be prong and pick with flat ball type clutch. The prong shall be
centered on the reverse side of the lapel button.
6. The full size identification badge shall conform to MIL-DTL-3628/156.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
(Project No. 8455-2005/020)
Review activities:
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the
currency of the information above using the ASSIST Online database at
https://assist.daps.dla.mil.
2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business