MIL-DTL-11484/21E
2. Enameled/epoxied areas shall be as shown. When hard enamel is used, the material
requirement shall be 95/15 gilding metal. When epoxy is used, the material requirement
shall be not less than
3. 85/15 rich-low brass. Colors shall conform to TIOH Hard Enamel Color Chip Numbers
listed below:
COLOR
CHIP NO.
Green
12
White
28
3. Attaching device shall be prong with pick and wing type clutch. The prong shall be
centered on the reverse side and fused or soldered to the lapel button.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy - NU
Review activities:
(Project No. 8455-2005/029)
Navy - MC
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the
currency of the information above using the ASSIST Online database at
https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business