MIL-DTL-11132/5H
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Piercing shall be as indicated.
3. With the exception of the attaching device and the dapping requirements, -1 and -2
are identical:
a. Attaching device for -1 shall be prong with clutch type. Two prongs shall be
located on the intersections of a horizontal line 11/16 inch ± 1/32 inch above the base of
the insignia and the center of each side of the wreath.
b. Attaching device for -2 shall consist of registration prongs and a screw post and
thumb nut. Two prongs shall be located as above. The post shall be located on the
vertical center line of the insignia at the center of the bar connecting the letters "ROTC."
c. -2 insignia shall be dapped in the horizontal direction through a radius of 4
inches ± 1/2 inch.
4. A mock forcer may be used to bring up the lettering.
5. At the option of the manufacturer, -1 may be die cast in zinc aluminum.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activities:
(Project No. 8455-0064/005)
DLA - CT
2 of 2