MIL-DTL-11132/40E
DEVICE:
HEIGHT (Overall): 1/2 inch (REF)
WIDTH (Overall): 1/8 inch (REF)
THICKNESS (Edge): 0.085 inch + 0.005 inch
ASSEMBLED THICKNESS (Thickest Point): 0.150 inch + 0.010 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Enameled areas shall be as indicated. The enamel colors shall match the TIOH
color chip numbers listed below:
CHIP NUMBER
COLOR
Red
1
Blue
18
Light Blue
30
3. Epoxy resin (stoning epoxy) may be used in lieu of hard enamel at the option of the
manufacturer.
4. The device shall be secured to the base by two solid brass rivets 0.035 inch
minimum in diameter located on the vertical center line of the device.
5. Attaching device shall be prong and clutch type. Prongs shall be attached on the
horizontal center line, equidistant from each side and 7/8 inch + 1/32 inch apart.
6. The base may be rhodium plated with a mirror-like polished finish at the option of the
manufacturer.
7. Acid test for the gold plated device shall not apply.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Air Force - 45
Review activities:
(Project No. 8455-0960)
Air Force - 32, 82, 99
DLA - CT
2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business