MIL-DTL-41819/8G
2. The attaching device shall be a staple type prong centered on the reverse of the
ribbon attachment. The staple type prong shall be located on the horizontal center line
equidistant from each end and 5/8 inch + 1/32 inch apart for the regular size and 3/8 inch +
1/32 inch apart for the miniature size.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was
done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Air Force - 11
Navy - NU
Review activities:
(Project No. 8455-2010-147)
Air Force - 99
Navy - MC
Coast Guard - CG
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 3 of 3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business