MIL-DTL-41819/21L
DIMENSIONS:
HEIGHT (overall): 3/16 inch (REF)
WIDTH (overall):
-1, -11: 1/16 inch (REF)
-2 through -10, -12 through -20: 11/64 inch (REF)
THICKNESS (at thickest point): 0.040 inch + 0.10 inch 0
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Except for numerals "4" and "0", the attaching device shall be a staple type prong
located on the horizontal center line of the numeral as close as possible to the vertical
center.
3. The attaching device for the numeral "4" shall be a staple type prong located at the
intersection for the vertical center line of the numeral and the center of the horizontal bar in
the numeral.
4. The attaching device for the numeral "0" shall have two prongs. One prong shall be
located at each intersection of the horizontal center line of the numeral and the center of
the vertical arms.
5. The numerals "0" and "3" shall be pierced.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy - NU
(Project No. 8455-2009-078)
Review activities:
Navy - MC
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the
currency of the information above using the ASSIST Online database at
2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business