MIL-DTL-3943/89G
THICKNESS (At thickest point):
-1: 0.140 inch ± 0.010 inch
-2: 0.105 inch ± 0.010 inch
DECORATION SET: Decoration set shall consist of a regular size medal, a miniature size
medal, a service ribbon, and a lapel button all packaged in a presentation case conforming
to MIL-C-14633, Type XII, Style 3 with a Class 1 or 1A pad.
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The specification slash sheet for the ribbon for the pendant drape and service ribbon
is MIL-DTL-11589/224
3. The specification slash sheet for the lapel button is MIL-DTL-11484/118.
4. This item is not authorized for commercial sale, and may be produced only under
Government contract and at the request of the Office of the Director of National Intelligence.
5. The service ribbon bar only is authorized for commercial sale.
EPOXY: Epoxy resin shall be applied to the lapel button as indicated above, and shall
match TIOH Hard Enamel Color Chip Numbers listed below.
TIOH HARD ENAMEL COLOR CHIP
COLOR
CHIP NUMBER
Dark Blue
#20
White
#28
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was done as
a convenience only and the Government assumes no liability whatsoever for any inaccuracies
in these notations. Bidders and contractors are cautioned to evaluate the requirements of this
document based on the entire content irrespective of the marginal notations and relationship to
the last previous issue.
Page 2 of 3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business