MIL-DTL-3943/164B
SUSPENSION BAR:
HEIGHT (including lug): 1/2 inch (REF)
WIDTH: 1-7/16 inches (REF)
THICKNESS (at thickest point): 0.100 inch + 0.010 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The lug for the reverse of the pendant shall be formed into a half circle from brass
wire. The lug shall be fabricated from 0.050 inch + 0.002 inch nominal diameter wire with
the same material and finish as the pendant. The lug shall have an outside diameter of
9/32 inch + 1/64 inch and shall be hard soldered to vertical center line of the back of the
pendant 3/32 inch from the top on center.
3. The wires for the suspension bar shall be fabricated from 0.050 inch + 0.002 inch
nominal diameter wire with the same material and finish as the suspension bar and hard
soldered in the location shown.
4. Decoration set presentation case shall be as specified by the procuring agency.
5. The ribbon for the pendant drape and service ribbon shall conform to
MIL-DTL-11589/382.
6. The lapel button shall conform to MIL-DTL-11484/223.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodians:
Preparing activity:
Army - IH
Army - IH
Review activities:
(Project No. 8455-2010-088)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business