MIL-DTL-3943/114F
2. The lug shall be 1/4 inch in diameter and shall be formed from 0.050 inch diameter
brass wire. The lug shall be located on the vertical center line of the pendant 3/16 inch +
1/16 inch below the top edge.
3. The lug shall be hard soldered in place.
4. The suspension ring shall be formed from 0.050 inch diameter brass wire and shall be
1/2 inch + 1/8 inch in diameter. The suspension ring shall be finished to match the
pendant.
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The neck ribbon shall be fabricated as shown on Figure 5 of MIL-DTL-3943 except
the shield shall be 1-1/4 inch + 0 - 1/8 inch square with the corners trimmed 1/4 inch.
3. The specification slash sheet for the ribbon for the pendant drape and for the service
ribbon is MIL-DTL-11589/303.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activity:
(Project No. 8455-2014-164)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the currency
of the information above using the ASSIST Online database at https://assist.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business