MIL-DTL-3943/111E
DIMENSIONS:
HEIGHT (including lug):
-1: 1-1/2 inches (REF)
-2: 3/4 inch (REF)
DIAMETER:
-1: 1-3/8 inches (REF)
-2: 11/16 inch (REF)
THICKNESS (at edge):
-1: 0.125 inch + 0.005 inch
-2: 0.075 inch + 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The reverse side shall be flat and suitable for engraving.
3. Decoration set shall consist of a regular size medal, a service ribbon and a lapel
button all packaged in a presentation case conforming to MIL-C-14633, Type XVI with a
Type XVI, Class 1 or 3 pad.
4. The ribbon for the pendant drape and service ribbon shall conform to
MIL-DTL-11589/298.
5. The lapel button shall conform to MIL-DTL-11484/142.
6. This item is not authorized for commercial sale, and may be produced only under
Government contract. A copy of the original purchase order from the Government Agency
concerned must accompany all written requests prior to the loan of a Government hub or die.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was
done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodians:
Preparing activity:
Army - IH
Army - IH
Review activities:
(Project No. 8455-2010-103)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business