MIL-DTL-3628-86 Badge, Qualification, Excellence In Competition, Pistol Shot, U.S. Air Force

Pages 1 - 2 - 3

MIL-DTL-3628/86C

ATTACHING DEVICE AND LUGS:

1. The attaching device shall be prong and clutch type.

2. The prongs shall be located on the horizontal center line of the suspension bar

equidistant from each end and 1-1/4 inches + 1/32 inch apart.

3. Lugs for the suspension bar and pendant shall be equidistant from each end and 7/8 inch +

1/64 inch on center. The lugs shall be fabricated from bronze wire for -1 and nickel plated wire

for -2 with a diameter of 0.050 inch + 0.005 inch. Lugs shall be hard soldered to the pendant or

bar.

4. Lugs shall be hard soldered to the pendant or bar.

5. Links shall be fabricated from nickel plated wire for -2 and copper wire for -1 with a

nominal diameter of 0.050 inch. The overall dimension of the links shall be 1/4 inch + 1/64 inch

in length and 7/32 inch + 1/64 inch in width.

6. The target and coat of arms shall be superimposed and secured to the pendant in the

location shown using soft solder.

NOTE:

The term (REF) refers to the measurements taken from the Government furnished hub or die.

CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to

identify changes with respect to the previous issue due to the extent of the changes.

Custodians:

Preparing activity:

Army - IH

Air Force - 11

Review activity:

(Project No. 8455-2014-213)

DLA - CT

NOTE: The activities listed above were interested in this document as of the date of this document.

Since organizations and responsibilities can change, you should verify the currency of the

information above using the ASSIST Online database at https://assist.dla.mil.

Page 3 of 3