MIL-DTL-3628-8 Badge, Qualification, Fleet Rifleman, Navy; Pendant And Suspension Bar

Pages 1 - 2 - 3

MIL-DTL-3628/8G

2. Enameled areas shall be as indicated. The color shall conform to TIOH Enamel

Color Chip Numbers listed below.

COLOR

CHIP NUMBER

Black

White

3. Epoxy resin (stoning epoxy) may be used in lieu of hard enamel at the option of

manufacturer. Epoxy resin shall be smooth and flush with the dikes.

4. The lug (suspension ring) for the pendant shall have a minimum outside diameter of

5/32 inch + 1/64 inch and wire thickness shall have a nominal thickness of 0.050 inch. The

lug shall be soldered at the top of the pendant vertical center line.

5. Suspension links shall be 5/32 inch + 1/64 inch in width by 3/16 inch + 1/64 inch in

length and fabricated from 0.050 inch nominal diameter wire with the same material and

finish as the pendant and suspension bar.

6. Jump rings shall be fabricated from 0.050 inch nominal diameter wire with the same

material and finish as the suspension bar. The rings shall have an outside diameter of

3/16 + 1/32 inch.

7. The attaching device shall be prong and flat ball clutch type. Nickel plated flat ball

clutches shall be used for Dash -2 and brass flat ball clutches shall be used for Dashes -1

and -3. The prongs shall be located on the horizontal center line of the suspension bar,

equidistant from each end and 1-11/32 inches + 1/32 inch apart.

8. The suspension bar shall have two integral lugs. The lugs shall be equidistant from

each end and 13/16 inch + 1/64 inch on centers.

9. The use of any type of plastic packaging material is prohibited.

CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to

identify changes with respect to the previous issue due to the extent of the changes.

Custodian:

Preparing activity:

Army - IH

Navy - NU

Review activities:

(Project No. 8455-2010-095)

DLA - CT

NOTE: The activities listed above were interested in this document as of the date of this document.

Since organizations and responsibilities can change, you should verify the currency of the

information above using the ASSIST Online database at https://assist.daps.dla.mil.

Page 3 of 3