MIL-DTL-3628/72F
cm) apart for Dash No. -1 and 1-3/8 inch + 1/64 inch (3.49 cm + 0.04 cm) apart for
Dash No. -4.
b. Dash No. -2 and -3: The prongs shall be located on the vertical center line
of the badge with the top prong centered on the star and the lower prong 1/4 inch +
1/64 inch (0.64 cm + 0.04 cm) from the bottom of the badge.
c. Dash No. -5 and -6: The prongs shall be located on the vertical center line
of the badge with the top prong centered on the star and the lower prong 3/16 inch
+ 1/64 inch (0.48 cm + 0.04 cm) from the bottom of the badge.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are
marked with vertical lines to indicate where changes from the previous issue were
made. This was done as a convenience only and the Government assumes no
liability whatsoever for any inaccuracies in these notations. Bidders and contractors
are cautioned to evaluate the requirements of this document based on the entire
content irrespective of the marginal notations and relationship to the last previous
issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Air Force 11
(Project No. 8455-2008-136)
Review activities:
Air Force - 99
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of
this document. Since organizations and responsibilities can change, you should
verify the currency of the information above using the ASSIST Online database at
https://assist.daps.dla.mil.
PAGE 3 OF 3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business