MIL-DTL-3628/7J
2. Enameled areas shall be as indicated. The color shall conform to TIOH Enamel
Color Chip Numbers listed below.
COLOR
CHIP NUMBER
Black
26
White
28
3. Epoxy resin (stoning epoxy) may be used in lieu of hard enamel at the option of
manufacturer. Epoxy resin shall be smooth and flush with the dikes.
4. The lug (suspension ring) for the pendant shall have a minimum outside diameter of
5/32 inch + 1/64 inch and wire thickness shall have a nominal thickness of 0.050 inch.
The lug shall be soldered at the top of the pendant vertical center line.
5. Suspension links shall be 5/32 inch + 1/64 inch in width by 3/16 inch + 1/64 inch in
length and fabricated from 0.050 inch nominal diameter wire with the same material and
finish as the pendant and suspension bar.
6. Jump rings shall be fabricated from 0.050 inch nominal diameter wire with the same
material and finish as the suspension bar. The rings shall have an outside diameter of
3/16 + 1/32 inch.
7. The attaching device shall be prong and flat ball clutch type. Nickel plated flat ball
clutches shall be used for Dash -2 and brass flat ball clutches shall be used for Dashes -1
and -3. The prongs shall be located on the horizontal center line of the suspension bar,
equidistant from each end and 1-11/32 inches + 1/32 inch apart.
8. The suspension bar shall have two integral lugs. The lugs shall be equidistant from
each end and 13/16 inch + 1/64 inch on centers.
9. The use of any type of plastic packaging material is prohibited.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was
done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy - NU
Review activities:
(Project No. 8455-2010-094)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 3 of 3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business