MIL-DTL-3628/62E
WIDTH (overall):
-1: 1-9/16 inches (REF)
-2: 13/16 inch (REF)
THICKNESS (thickest point at shield):
-1: 0.125 inch + 0.005 inch
-2: 0.085 inch + 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Piercing shall be as indicated.
3. The attaching device shall be prong and clutch type. The prongs shall be located as
follows:
Dash No. -1: One prong shall be located on the vertical center line 1/8 inch + 1/16
inch from the bottom of the badge. Two prongs shall be located on a horizontal line 1-3/16
inches + 1/16 inch from the bottom of the badge, equidistant from each side and 1-3/16
inches + 1/16 inch apart.
Dash No. -2: Two prongs shall be located on a horizontal line 7/16 inch + 1/6 inch
from the bottom of the badge, equidistant from each side and 11/16 inch + 1/16 inch apart.
4. Shield, anchor and rope may be rhodium plated, mirror-like polished and shall match
TIOH Metal Finish Chip Number 16 at the option of the manufacturer.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy - NU
(Project No. 8455-2009-006)
Review activities:
DLA - CT
Coast Guard - CG
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the
currency of the information above using the ASSIST Online database at
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business