MIL-DTL-3628/46F
DIMENSIONS:
HEIGHT (Overall):
ASSEMBLED: 2 inches (REF)
PENDANT (Excluding Lugs): 1-1/2 inch (REF)
SUSPENSION BAR (Excluding Lugs): 9/32 inch (REF)
WIDTH (Overall):
PENDANT: 1 inch (REF)
SUSPENSION BAR (Including Balls): 1-17/32 inches (REF)
THICKNESS:
PENDANT (At Thickest Point): 0.110 inch + 0.005 inch
SUSPENSION BAR (At Rim): 0.065 inch + 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The lugs are an integral part of both the pendant and the suspension bar.
3. The connecting links shall be formed from 0.042 inch + 0.002 inch diameter wire,
shall be oblong shaped and 3/16 inch + 1/64 inch long by 1/8 inch + 1/64 inch wide.
4. The attaching device shall be a prong and flat ball clutch type. The prongs shall be
located on the horizontal center line of the back of the suspension bar equidistant from
each end and 1-1/8 inches + 1/32 inch apart.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was
done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy - MC
(Project No. 8455-2009-102)
Review activities:
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the
currency of the information above using the ASSIST Online database at
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business