MIL-DTL-3628/43F
6. The attaching device shall be a prong and flat ball clutch type. Red brass flat ball
clutches shall be used for Dash No. -1 and -3. Nickel plated flat ball clutches shall be used
for Dash No. -2. The prongs shall be located on the horizontal center line of the
suspension bar, equidistant from each end and 1-1/16 inches + 1/32 inch apart.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was
done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy NU
(Project No. 8455-2010-011)
Review activities:
Navy - MC
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the
currency of the information above using the ASSIST Online database at
Page 3 of 3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business