MIL-DTL-3628/4H
DIMENSIONS:
PENDANT:
HEIGHT (overall): 1-17/64 inches (REF)
WIDTH (overall): 1-1/16 inches (REF)
THICKNESS (at edge): 0.062 inch + 0.005 inch
SUSPENSION BAR:
HEIGHT (overall): 9/32 inch (REF)
WIDTH (overall): 1-1/2 inches (REF)
THICKNESS (edge): 0.062 inch + 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Enameled areas shall be as indicated. The color shall conform to TIOH Enamel
Color Chip Numbers listed below.
COLOR
CHIP NUMBER
Black
26
White
28
3. Epoxy resin (stoning epoxy) may be used in lieu of hard enamel at the option of
manufacturer. Epoxy resin shall be smooth and flush with the dikes.
4. The links shall be fabricated from gold plated wire with a nominal diameter of
0.050 inch + 1/64 inch. The overall dimension of the links shall be 7/32 inch
+ 1/64 inch in length by 5/32 inch + 1/64 inch in width.
5. The lugs are integral.
6. The attaching device shall be a prong and flat ball clutch type. The prongs shall be
located on the horizontal center line of the suspension bar, equidistant from each end and
1-1/16 inches + 1/32 inch apart.
7. The use of any type of plastic packaging material is prohibited.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy - NU
Review activities:
(Project No. 8455-2010-059)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business