MIL-DTL-3476-41 Brassard, Military Police, U.S. Marine Corps, Subdued

Pages 1 - 2

MIL-DTL-3476/41B

CONSTRUCTION DETAILS:

1. The base cloth for the letters shall be a plain weave.

2. Lettering shall be appliqu�d to the base in the position shown. The appliqu� thread shall be

50/3 ply soft cotton and use Stitch Type 304 of ASTM-D-6193 with a 1/8 inch throw with 24-30

stitches per inch. The appliqu� stitch shall completely cover the edge of the lettering.

3. The loop shall be located on the vertical center line of the brassard with the base 1-1/4 inches +

1/16 inch below the top edge of the brassard and shall be attached to the back of the brassard as

shown. A bar tack may be used to secure the loop in lieu of box stitching at the option of the

manufacturer. However, the ends of the tape must be secured and completely covered by the

stitching. The thread for stitching the loop shall conform to Type III, 3 Ply, Ticket No. A of A-A-

52094

4. The attaching device shall be hook and pile, olive green (shade 106) and conform to Type II,

Class 1 of A-A-55126. The hook and pile fastener shall be positioned and secured to the base

fabric as shown using Stitch Type 301 with 12 stitches per inch.

5 Overedge stitching shall be superimposed around the complete border of the brassard. The

stitching shall conform to Stitch Type 504 or 505 of ASTM-D-6193 with 24 stitches per inch. The

cover thread shall completely cover the cut edges of the brassard.

CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to identify

changes with respect to the previous issue due to the extent of the changes.

Custodians:

Preparing activity:

Army - IH

Navy - MC

Review activity:

(Project No. 8455-2014-094)

DLA - CT

NOTE: The activities listed above were interested in this document as of the date of this document.

Since organizations and responsibilities can change, you should verify the currency of the information

above using the ASSIST Online database at https://assist.dla.mil.

Page 2 of 2