MIL-DTL-3476/14D
2. A bar tack may be used to secure the loop in lieu of box stitching at the option of the
manufacturer. However, the ends of the tape must be secured and completely covered by the
stitches.
3. The loop shall be located on the vertical center line of the brassard with the base 1-1/4 inches +
1/16 inch below the top edge of the brassard and shall be attached to the back of the brassard as
shown.
4. Thread for appliquéing shall conform the Type IC1, 3 Ply, Ticket A of A-A-52094. The thread
for stitching the loop shall conform to Type IC2, 3 Ply, Ticket A of A-A-52094.
5. The device and base shall be cut from a single ply of the material specified.
6. The color of the thread for appliquéing shall conform to White Cable No. HA 67101. The color
of the thread for sewing the loop shall conform to Dark Blue Cable No. HAA 67126
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to identify
changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activity:
(Project No. 8455-2014-144)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the information
above using the ASSIST Online database at https://assist.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business