MIL-DTL-15665/30E
DIMENSIONS:
HEIGHT (Overall): 2-1/2 inches (6.35 cm) (REF)
WIDTH (Overall): 1-3/4 inches (4.45 cm) (REF)
THICKNESS (Maximum): 0.040 inch + 0.005 inch (0.102 cm + 0.012 cm)
NOTES:
1. The term (REF) refers to measurements taken from the Government
furnished hub or die.
2.
A full forcer shall be used to bring up the design.
3.
Pierced area shall be as indicated.
4. The attaching device shall be a screw post with thumb nut and a
registering prong. The screw post shall be located on the vertical center
line 1-1/4 inch + 1/64 inch (3.18 cm + 0.04 cm) above the bottom of the
insignia. The registering pin shall be located on the vertical center
line 3/8 inch + 1/64 inch (0.95 cm + 0.04 cm) below the top of the
insignia.
5. The registering prong shall be 1/4 inch + 1/64 inch (0.64 cm +
0.04 cm) in length and 0.032 inch + 0.002 inch (0.081 cm + 0.005 cm) in
diameter.
6. The screw post shall be 1/8 inch (0.32 cm) in diameter, 3/4 inch +
1/32 inch (1.91 cm + 0.08 cm) in length with 5-40 UNC-2A thread and the
thumb nut shall be 5/8 inch + 1/64 inch (1.59 cm + 0.04 cm) in diameter
with a No. 5-40 UNC-2B thread. Screw post and thumb nut shall be
fabricated from any type brass.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this
revision to identify changes with respect to the previous issue due to the
extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activities:
(Project No. 8455-0843)
DLA - CT
2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business