MIL-DTL-15665-12 Insignia, Collar, Enlisted, And Cap, Garrison, Enlisted, Marine Corps

Pages 1 - 2

MIL-DTL-15665/12H

WIDTH (Overall): 15/16 inch (2.38 cm) (REF)

THICKNESS (Minimum): 0.040 inch + 0.005 inch (0.101 cm + 0.012 cm)

NOTES:

1. The term (REF) refers to measurements taken from the Government

furnished hub or die.

Forcers shall be used to bring up the design.

3. Dash Numbers -1 and -2 shall be made in pairs (one left hand and

one right hand).

Dash Numbers -3 and -4 shall be the left hand insignia only.

5. Flat black enamel for Dash Numbers -2 and -4 shall conform to FED-

STD-595, Color Chip Number 37038.

6. The attaching device shall be a screw post with nut. The screw

post shall be 3/8 inch + 1/32 inch (0.95 cm + 0.08 cm) long, 1/8 inch

(0.32 cm) in diameter and shall have a No. 5-40 UNC-2A thread. The thumb

nut shall be 0.625 inch + 0.010 inch (1.588 cm + 0.025 cm) or 0.500 inch +

0.010 inch (1.27 cm + 0.025 cm) in diameter and shall have a No. 5-40 UNC-

2B thread.

7. The screw post shall be soldered or electronically fused the

insignia in the center of the globe as indicated.

8. The registering prong shall be 3/16 inch + 1/64 inch (0.32 cm +

0.04 cm) in length and 0.032 inch + 0.002 inch (0.081 cm + 0.005 cm) in

diameter. The prong shall be fused or soldered on the vertical center

line on the back of the eagle's breast.

9. Trimming on both sides of the eagle's head to be accomplished

without altering or distorting the design detail.

CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this

revision to identify changes with respect to the previous issue due to the

extent of the changes.

Custodian:

Preparing activity:

Army - IH

Navy - NU

Review activities:

Project No. 8455-2006-019)

Navy - MC

DLA - CT

NOTE: The activities listed above were interested in this document as of

the date of this document. Since organizations and responsibilities can

change, you should verify the currency of the information above using the

2 of 2