MIL-DTL-15665/113
DIMENSIONS:
EAGLE AND SHIELD:
HEIGHT: 1-1/4 inches (REF)
WIDTH: 13/16 inch (REF)
THICKNESS (Edge of Shield): 0.069 inch + 0.010 inch
DEVICE:
HEIGHT: 1/4 inch (REF)
WIDTH: 17/16inch (REF)
Thickness: 0.085 inch + 0.010 Inch
ATTACHING DEVICE:
1. Attaching device should be prong and wing type clutch.
2. Prongs should be located on the vertical center line equidistant from each end and
7/8 inch + 1/64 apart.
EPOXY: Epoxy shall be applied as indicated above and as specified in the table below, and
shall match the TIOH Hard Enamel Color Chip Number listed. Hard cloisonné enamel may
be used in lieu of epoxy enamel. If hard Cloisonné enamel is used, the required base
material for -1 and -2 shall be Gilding Metal 95/5 (UNS Alloy C-210):
TIOH HARD ENAMEL
ITEM
LOCATION
COLOR CHIP NUMBER
Blue #18
-1, -2
Shield, as indicated in the above drawing
Blue #20
-1, -2
Shield, as indicated in the above drawing
White #28
-1, -2
All the stars on the shield
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished hub or
die.
2. Pierced areas as indicated.
3. The device should be superimposed and secured to the shield by two rivets or soft
soldered. When rivets are used, they should be solid and fabricated from any type.
brass. The rivets should be located on and soldered to the vertical center line of the
device. The device should be located on the insignia as indicated.
4. Eagle on Shield will be modeled.
5. May be manufactured using 22 karat gold plate with nickel underplating as follows
for commercial sale only:
EAGLE: Gold Plated, Matte Finish, Polished Highlights and shall match TIOH
Metal Chip Number 11.
Page 2 of 3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business