MIL-DTL-11484/93D
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Lapel button shall be lacquered.
3. Attaching device shall be prong with pick and wing type clutch. The prong shall be
centered on the reverse side and fused or soldered to the lapel button.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was done as
a convenience only and the Government assumes no liability whatsoever for any inaccuracies
in these notations. Bidders and contractors are cautioned to evaluate the requirements of this
document based on the entire content irrespective of the marginal notations and relationship to
the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
DIA DI
(Project No. 8455-2008-201)
Review activities:
DLA - CT
Page 2 of 2