MIL-DTL-11484/30G
DIMENSIONS:
DIAMETER: 17/32 inch (REF)
THICKNESS: 0.050 inch ± 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The designs for -1 and -4 are identical to the figure shown. The designs for -2, -3, -
5, and -6 are identical to the figure shown except for the stone located at the center of the
eagle's breast. The stones shall be set in the eagle's breast with a three or four bead
setting.
3. All lapel buttons shall be lacquered.
4. Attaching device shall be as follows:
-1, -2, -3: Prong with pick and flat ball clutch. The prong shall be centered on the
reverse side and fused or soldered to the lapel button.
-4, -5, -6: Pin and catch type fused or soldered to the reverse of the lapel button.
The pin shall be located on the horizontal center line of the lapel button with hinge
and catch equidistant from the outer edges.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodians:
Preparing activity:
Army - IH
Army - IH
Air Force - 11
Review activities:
(Project No. 8455-0093/001)
Air Force - 99
DLA - CT
2 of 2