MIL-DTL-11484/26E
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. Enameled/epoxied areas shall be as shown. Epoxy resin (stoning epoxy) may be at
the option of the manufacturer. When hard enamel is used, the material requirement shall
be gilding metal. When epoxy is used, the material requirement shall be either red brass or
gilding material. Colors shall conform to TIOH Hard Enamel Color Chip Numbers listed
below:
COLOR
CHIP NO.
Yellow
8
Blue
20
White
28
3. Attaching device shall be prong with pick and wing type clutch. The prong shall be
centered on the reverse side and fused or soldered to the lapel button.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was
done as a convenience only and the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Navy NU
(Project No. 8455-2008-167)
Review activities:
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the currency
of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business