MIL-DTL-11484/22E
2. Enameled/epoxied areas shall be as shown. Epoxy resin (stoning epoxy) may be at the
option of the manufacturer. When hard enamel is used, the material requirement shall be
gilding metal. When epoxy is used, the material requirement shall be either red brass or
gilding material. Colors shall conform to TIOH Hard Enamel Color Chip Numbers listed
below:
COLOR
CHIP NO.
Yellow
8
Blue
20
3. Attaching device shall be prong with pick and wing type clutch. The prong shall be
centered on the reverse side and fused or soldered to the lapel button.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was done as
a convenience only and the Government assumes no liability whatsoever for any inaccuracies
in these notations. Bidders and contractors are cautioned to evaluate the requirements of this
document based on the entire content irrespective of the marginal notations and relationship to
the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Air Force 11
(Project No. 8455-2008-163)
Review activities:
Air Force - 99
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the currency
of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business