MIL-DTL-11484/201B
WIDTH:
BASE: 27/64 inch (REF)
DEVICE: 13/32 inch (REF)
THICKNESS:
BASE (at thickest point, horizontal arrows): 0.050 inch ± 0.005 inch
DEVICE (at wing tips): 0.040 inch ± 0.005 inch
ASSEMBLED (at eagle s breast): 0.100 inch ± 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished hub
or die.
2. The base shall be lacquered.
3. Attaching device shall be prong with pick and flat ball clutch. The prong shall be
centered on the reverse side and fused or soldered to the lapel button.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification are marked with
vertical lines to indicate where changes from the previous issue were made. This was done as
a convenience only and the Government assumes no liability whatsoever for any inaccuracies
in these notations. Bidders and contractors are cautioned to evaluate the requirements of this
document based on the entire content irrespective of the marginal notations and relationship to
the last previous issue.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activity:
(Project No. 8455-2010-386)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the
information above using the ASSIST Online database at https://assist.daps.dla.mil.
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business