MIL-DTL-11484/150C
2. Attaching device shall be prong with pick and flat ball type
clutch or pin and catch as specified by the contracting officer. When a
prong with pick and flat ball type clutch is specified, the prong shall be
centered on the reverse side and fused or soldered to the lapel button.
When a pin and catch is specified, the pin shall be mounted on the
vertical center line with the catch on the bottom of the lapel button.
3. For packaging, each finished lapel button shall be mounted and
centered on a sulfite board with a minimum thickness of 0.030 inch (0.076
cm) and approximately 3-3/4 inches (9.53 cm) in length by 2-1/4 inches
(5.72 cm) wide. The face of the sulfite board shall be covered with
cobalt blue flock. The mounted sulfite board shall be placed in a rigid
hinged plastic box having a transparent lid and opaque white bottom
section. The box shall have two plastic hinges and catches and shall be
approximately 3 inches (7.62 cm) in length and 1-1/4 inches (3.18 cm) wide
and 3/4 inch (1.91 cm) in overall depth.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this
revision to identify changes with respect to the previous issue due to the
extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activities:
(Project No. 8455-0858)
DLA - CT
Civil Agency Coordinating Activity:
GSA- 7FXE
2 of 2