MIL-DTL-11484/111C
DEVICE:
HEIGHT (Overall): 11/32 inch (0.36 cm) (REF)
WIDTH (Overall):
5/16 inch (0.79 cm) (REF)
THICKNESS (At Thickest Point): 0.045 inch + 0.005 inch (0.114 cm +
0.012 cm)
ASSEMBLED THICKNESS (At Thickest Point): 0.105 inch + 0.010 inch (0.267 cm
+ 0.025 cm)
NOTES:
1. The term (REF) refers to the measurements taken from the
Government furnished hub or die.
2. Enameled areas shall be as indicated. The colors shall conform to
the TIOH color chip numbers listed below or the standard sample.
COLOR
CHIP NO.
Red
1
Blue
18
White
28
3. Epoxy resin (stoning epoxy) may be used in lieu of hard enamel at
the option of the manufacturer.
4. The device shall be centered on the vertical center line of the
base and shall be soft soldered to the base. When epoxy resin is used,
the device shall be attached to the base by rivets.
5. Attaching device shall be prong with pick and flat ball type
clutch. The prong shall be centered on the reverse side and fused or
soldered to the lapel button.
6. Each lapel button shall be mounted and centered on a polyethylene
pad and placed in a rigid hinged plastic box having a transparent lid and
opaque bottom section. The box shall have two plastic hinges and catches
and shall be approximately 1-1/8 inches (2.86 cm) square and 5/8 inch
(1.59 cm) in overall depth. The pad shall be of sufficient depth to
restrict movement of the lapel button when the lid is closed.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this
revision to identify changes with respect to the previous issue due to the
extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activities:
(Project No. 8455-0858)
DLA - CT
2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business