MIL-DTL-11132/6L
DIMENSIONS:
HEIGHT (overall):
-1: 1-7/32 inches (REF)
-2: 1-5/16 inches (REF)
-3: 2-1/2 inches (REF)
WIDTH (overall):
-1: 23/32 inches (REF)
-2: 31/32 inches (REF)
-3: 1-1/2 inches (REF)
THICKNESS:
-1, -2 (thickest point of shield): 0.100 inch + 0.005 inch
-3 (at edge): 0.065 inch + 0.005 inch
ATTCHING DEVICE:
1. The attaching device for -1 and -2 shall be prong and clutch type.
2. Prongs shall be located on the vertical center line 7/8 inch + 1/32 inch apart with the
bottom prong 7/32 inch + 1/32 inch above the bottom of the insignia.
3. The attaching device for -3 shall be a screw post, thumb nut, and registration prong.
The screw post shall be located on the vertical center line 1-5/16 inches + 1/32 inch above
the base of the insignia. The registration prong shall be located on the vertical center line
3/16 inch + 1/32 inch below the top of the insignia.
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. A mock forcer may be used for -3 to bring up the design provided the forced area
maintains a minimum thickness of 0.045 inch.
3. Piercing for -2 shall be between the upper three stars of the five stars arrayed to either
side of the device and the eagle only. Please see illustration -2 on page 1 of this
specification.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Air Force - 11
Review activity:
(Project No.8455-2014-024)
DLA - CT
NOTE: The activities listed above were interested in this document as of the date of this
document. Since organizations and responsibilities can change, you should verify the currency
Page 2 of 2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business