MIL-DTL-11132/3G
EMBOSSED DEVICE:
HEIGHT (overall): 3/4 inch (REF)
WIDTH (overall): 7/16 inch (REF)
THICKNESS (at thickest point): 0.080 inch ± 0.005 inch
NOTES:
1. The term (REF) refers to the measurements taken from the Government furnished
hub or die.
2. The dull flat black enamel for -2 shall match FED-STD-595, Chip No. 37038.
3. Attaching device for -1 shall be back plate with prong and clutch. Details and
dimensions shall conform to those shown on TIOH Drawing 4-4-89. The back plate shall
be fabricated from any type 1/4 hard brass; the prongs shall be fabricated from hard
drawn brass and shall be driven or electronically fused to the back plate.
4. Subdued insignia (-2) may be made in one piece.
5. Attaching device for -2 shall be prong and clutch type. The prongs shall be
positioned on the horizontal center line, an equal distance apart, but not less than 1/16
inch from the outer edge of the disc.
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
Custodian:
Preparing activity:
Army - IH
Army - IH
Review activities:
(Project No. 8455-0064/003)
DLA - CT
2 of 2